Manual SmartPAC installation on MacOS

To install SmartPAC manually, select your network connection icon, and open the “Network Preferences” panel.


Next, select the “Advanced” section. 


Finally, select “Proxies” and place a check in the “Automatic Proxy Configuration” box. The final step will be to place your SmartPAC URL (provided by Securly Support) into the “Proxy Configuration File” box, and click OK, then “Apply” to save these settings. 


SmartPAC is now installed on your device!

You can test if Securly works well on your devices by following these steps


(Note that the screenshots in this article are representative and taken on MacOS 12.3 Monterey)

Was this article helpful?
0 out of 4 found this helpful
Have more questions?
Submit a request



Article is closed for comments.

Articles in this section

See more